Supported MIB: CISCO-ENTITY-FRU-CONTROL-MIB (All Cisco devices that use these MIBs can be monitored using OpManager) Supported MIBs: Cisco-envmon-mib | ENTITY-MIB MIB Check if Hardware status is not updated:įor OpManager to monitor the hardware of your devices, check if the following OIDs are responding properly.
You can also go to the Hardware tab in the Device Snapshot page and suppress the hardware alarm for a particular device.Ħ.To suppress all the Hardware Alarms for all devices: Go to Settings → Monitoring → Monitor Settings → Hardware tab and click on Suppress Alarms under Hardware section.Check if the hardware alarms for the respective devices have been suppressed in OpManager.Check if Hardware monitoring is enabled for the individual devices in the Device snapshot → Hardware tab (Navigate to Inventory -> Devices and then click on a device to open its snapshot page.) 5. Check whether Hardware monitoring is enabled under Settings → Monitoring → Monitor Settings → Hardware.Ĥ. If it is not responding, then OpManager won't show the tabs.ģ. Query the below OIDs and check if it responds for all the OIDs if it responds then rediscover the device.
If the sensors are not available, install VMware tools on that host. Note that OpManager raises alerts based on the colour value available (alerts are raised if the colour is anything other than "green"). For hardwareStatusInfo: content → rootFolder → childEntity → hostFolder → childEntity → host → runtime → healthSystemRuntime → hardwareStatusInfo → cpuStatusInfo (or) memoryStatusInfo (or) storageStatusInfo.For numericSensorInfo: content → rootFolder → childEntity → hostFolder → childEntity → host → runtime → healthSystemRuntime → systemHealthInfo → numericSensorInfo.After logging into the MOB, navigate to the paths given below and check if values are being populated for both the methods: For hardwareStatusInfo (cpuStatusInfo / memoryStatusInfo / storageStatusInfo):.To make sure hardware monitoring works properly, check whether sensor information are available on MOB by using the following MOB link: OpManager uses the methods hardwareStatusInfo and numericSensorInfo from VMware API to poll the hardware status and stats of devices in the VMware environment. If you find the hardware tabs missing, follow the below steps: 1. If Hardware Sensor Monitors are not displayed, then please make sure that Dell OpenManage has been installed on that server. If Hardware Sensor Monitors are not displayed, then please make sure that these tools are installed on that server: